Silicone Emulsion is a Mould Release agent for
Rubber and Plastic Industries. In Rubber Industries like Tyres, Tubes, Fan belts, Hoses, Gaskets
and many other rubber parts.
Silicone Emulsion
acts as an efficient and economical release,
and shining Agent.
Properties :
Silicone Emulsion does not gum, or form carbonaceous deposits that
build up on process equipment to cause expensive product rejection.
Release is complete, clean and surface finishes are blemish free and sharp
in details.
It improves safety and
working conditions and acts an antistick material and eliminates need.
It is even non-volute and oxidation resistant.
Typical Physical Properties :
Chemical
Nature
|
Silicone Emulsion
Dimethylpolsiloxane
|
|
Sp. Gr.
|
Amount
1.00
|
|
Nature
|
Non-Ionic
|
|
PH
|
7 - 8
|
|
Diluent
|
Water
|
|
Silicone
Solids
|
20
to 50%
(As per your Request)
|
Method
Of Applications
:
Before applying Silicone Emulsion
the mould should be completely wetted which
assures a continuous, stable parting film and helps minimize cost per
moldings. Thus it eliminates
sticking in extruders, moulds, calendars,
and other equipments
throughout the rubber processing operation. The technique
for
applying Silicone Emulsion
varies because of
deference in production equipment. Silicone
Emulsion may sprayed automatically
or applied manually by swabbing, wiping, dipping
or hand spraying
Note: The information presented here is based on our present state of knowledge which we believe to reliance
but we cannot accept any responsibility for operation not under our direct control.
It is offered solely for your consideration, innovation and verification.
PACKING
: 1
Kg , 5 Kg, 30 Kg & 50 Kg Jar.
